1.5m 3D Touch Bed Automatically Level Sensor Print Compensation Sensor
New
20 were available
R423.00
0% off
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable. Check my rate
The seller has indicated that they will usually have this item
ready to ship within 12 business days.
Shipping time depends on your delivery address.
The most accurate delivery time will be calculated at checkout,
but in general, the following shipping times apply:
Replacement Guarantee:
7 Days: We stand by this guarantee
Get it now, pay later
Product details
Condition
New
Location
International
Bob Shop ID
645567358
1. The 3D Touch automatic leveling sensor is a device that uses the Hall effect to achieve leveling 2. The position of the point can be obtained by touching the point on the heating bed, and then compensated by adjusting the Z-axis height during printing, so that printing can be realized even when the platform is uneven 3. Rated current: 300mA 4. Shell material: PC 5. Voltage: 5V 6. Current: 15mA Shipping list: -1 x 20cm wire -1 x 1/1.5m wire -1 x Sensor -1 x Wound terminal -1 x XH2.542pin terminal -1 x XH2.543pin terminal -2 x M3 nuts/nails
