1.5m 3D Touch Bed Automatically Level Sensor Print Compensation Sensor

New

20 available

R423.00

Add to watchlist Watch

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou4172

91.70 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Product details

Condition

New

Location

International

Bob Shop ID

656760405

1. The 3D Touch automatic leveling sensor is a device that uses the Hall effect to achieve leveling 2. The position of the point can be obtained by touching the point on the heating bed, and then compensated by adjusting the Z-axis height during printing, so that printing can be realized even when the platform is uneven 3. Rated current: 300mA 4. Shell material: PC 5. Voltage: 5V 6. Current: 15mA Shipping list: -1 x 20cm wire -1 x 1/1.5m wire -1 x Sensor -1 x Wound terminal -1 x XH2.542pin terminal -1 x XH2.543pin terminal -2 x M3 nuts/nails

Report a problem