1 Channel DC 12V Wireless Remote Switch - Transmitter & Receiver - 3 Control Modes

1 Package includes:

• 1 X Receiver: 1 Channel / 3 Control Modes
• 1 X Transmitter
• 1 x User manual

Feature:

• Wireless control, easy to install.
• Control Lights, TVs, Motors, Fans, Cameras, Video signals, Audio signals, Electrically operated Doors/ Locks/ Windows/ Blinds/ Cars or Other Appliances with voltage AC110~240V or DC0~28V.
• You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance, the wireless signal can pass through walls, floors and doors.
• The receiver has further working range with external telescopic antenna !
• Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code.
• One/ several transmitters can control one/ several receivers simultaneously.
• If you use two or more receivers in the same place, you can set them with different codes.
• Transmitting Frequency: 315MHz / 433MHz

Receiver:

• Channel: 1 CH
• Control Modes: Toggle, Momentary, Latched
• Coding Type: Fixed code or Learning code
• Coding Setting: By learning
• Power Supply (Operating Voltage): DC12V±1V 
• Working Voltage Range of Relay: AC110~240V or DC0~28V
• PCB size: 68mm x 48mm x 20mm
• Length of the external telescopic antenne : 80mm / 305mm (stretch)
• Case size: 75mm x 55mm x 30mm
• Static Current: ≤6mA
• Maximum Working Current: 5A / each channel

Transmitter:

• Channel: 2 CH
• Remote Control Distance: Up to a 1000m / 3000ft (theoretically)
• Encode: Fixed code by soldering
• Unit size: 135mm x 42mm x 25mm
• Power Supply: 1 x 6F22-9V battery (included, can be used for 12 months)

Usage:

• 1) Setting control mode Toggle: Connect Jumper-2.
  Control mode Toggle: Press -> On; Press again -> Off.
  Press big button: Turn on the relay (connect B and C, disconnect A and B)
  Press big button again: Turn off the relay (disconnect B and C, connect A and B)
• 2) Setting control mode Momentary: Connect Jumper-1.
  Control mode Momentary: Press and hold -> On; Release -> Off.
  Press big button and hold: Turn on the relay (connect B and C, disconnect A and B)
  Release big button: Turn off the relay (disconnect B and C, connect A and B)
• 3) Setting control mode Latched: Disconnect Jumper-1 and Jumper-2.
  Control mode Latched: Press -> On, other relays Off; Press another button -> Off.
  Press big button: Turn on the relay (connect B and C, disconnect A and B)

Note:

• The distance of 1000m is a theoretical data, it shall be operated in an open ground, no barriers, no any interference. But in the practice, it will be hindered by trees, walls or other constructions, and will be exposed to some interference by other signals. Therefore, the actual distance could not reach 1000m.