1 inch to 9/ 8 inch Gas Engine Pulley Crank Shaft Sleeve Adapter Predator with 1/4 inch Keystock
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
CMS2519
Bob Shop ID
593627930
1. Alters motors with a different diameter shaft.
2. Alters pulleys for a different speed or belt.
3. Reduces the necessity of buying a new motor or pulley to maintain existing components and speed/power requirements.
4. Adapts larger wheel bores to smaller axels.
5. Works with Gas Engine Crank Shafts to enlarge the crank diameter to fit pulleys, gear boxes etc.
6. Specification:
Sleeve inside diameter 1 inch
Sleeve outside diameter 1-1/8 inch
Sleeve length is about 3 inch
Sleeve Keyway slot 1/4 inch
Keystock Length is about 2 inch
7. The sleeve and keystock are designed to slip fit on your 1 inch diameter crankshaft with 1/4 inch keyway and enlarge it to 1-1/8 diameter with 1/4 inch keystock.
8. Material: iron
2. Alters pulleys for a different speed or belt.
3. Reduces the necessity of buying a new motor or pulley to maintain existing components and speed/power requirements.
4. Adapts larger wheel bores to smaller axels.
5. Works with Gas Engine Crank Shafts to enlarge the crank diameter to fit pulleys, gear boxes etc.
6. Specification:
Sleeve inside diameter 1 inch
Sleeve outside diameter 1-1/8 inch
Sleeve length is about 3 inch
Sleeve Keyway slot 1/4 inch
Keystock Length is about 2 inch
7. The sleeve and keystock are designed to slip fit on your 1 inch diameter crankshaft with 1/4 inch keyway and enlarge it to 1-1/8 diameter with 1/4 inch keystock.
8. Material: iron