1 Pair POE Adapter Cable Tape Screened POE Switch Cable POE Splitter Injector Power Supply 12V Synth

20 available / new

R279.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3531

93.40 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Condition

New

Location

International

Bob Shop ID

643353540

Description:

The complete Passive Power over Ethernet SET contains two pieces - INJECTOR and SPLITTER. It is suitable for using with products that basically do not support Power Over Ethernet. Passive Power Over Ethernet SET is applicable for wide range of network products such as Access Points, Routers, IP cameras, modems, switches, embedded computers or other network devices. Passive Power over Ethernet SET is compatible with most devices available on the market such as D-Link, Linksys, Airlive, Senao, Wline, Micronet, Edimax etc. The devices can be supplied standardly up to 50V. (The power adapter is not included - it is possible to use the power adapter of the powered device as access point, IP camera etc.) Passive PoE`s range is normally form 30-40 metres/100-130 ft (the real distance depends on the power supply, type of cable and powered device). Contains: INJECTOR and SPLITTER. Complete set for wide range of network products such as Access Points, Routers, IP cameras, modems, switches, embedded computers or other network devices such as D-Link, Ovislink, Senao, Wline, RouterBOARD, WRAP boards and other devices using passive POE injection. Connector Barrel size is 2.1mm (5.5 x 2.1 mm) Power Pins 4,5 + and 7,8 - 1. It is very simple to connect a passive PoE. On the lower part, we connect the Ethernet RJ connector of passive PoE to the PC, Hub or Switch and connect the power adapter to the power socket. 2. On the opposite end (RJ socket) we connect the Ethernet cable leading to the far end. 3. At the far end, we connect the end of the Ethernet cable to the RJ45 socket and connect the power connectors and the Ethernet to the powered equipment. The equipment is now connected by them. Input / Output Specifications:
Supports Voltage: 5V, 12V, 24V, 48V Support Voltage Max Output Current 0.4A Max. Over Current Protection None General Sepcifications:
Operating Temperature 0ﾣ ~ +45ﾣ Storage Temperature -30oC ~ +70oC CASE OF MATERIAL PVC Ethernet Date Rate 10/100Mbps Ethernet Cable TIA/EIA 568 Cat.5 Humidity Up to 90% Weight: 24g*4 DC Plugs 2.1mmx5.5mmx12mm Length 155mm Package Included:
1 pair RJ45-DC Splitter