10 Meter Cut-to-Length Pure Nickel Ni200 / Ni201 Coil Wire 24AWG (0.50mm) Zero Resistance heating wi

Please note!! Ni200 / Ni201 wire is to be used by experienced vapers only. When using Ni200 / Ni201 wire for rebuilding coils you MUST have a temperature controlled Mod / Device such as the Evic VT which will control the wire temperatures to ensure you are not exposed to any danger.

If your Mod / Device is not temperature controlled please use Kanthal A1 28 AWG, Kanthal A1 26AWG, Kanthal A1 24AWG to rebuild your coil.

This pure Nickel wire is commonly used to rebuild the RBA Deck Coil supplied with Kanger Subtank Mini / Plus but can also be used for coil rebuild for Aspire / Atlantis and other RBA Decks with a temperature controlled mod used. To assist in rebuilding your coil use the RDA / RBA Deck Toolkit

When rebuilding a coil the organic cotton on the RBA Deck will also needs to be replaced and sheets can be found here.

Ni201 / Ni200 wire will allow you to reach subohm resistances of as low as 0.06 Ohm depending on number of winds of coil.