10 PCS 8 Port PCT Series Architectural Wiring Connector LED Lamp Conductor Distributor Junction B...
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
EPS2661
Bob Shop ID
605075376
1. Material: PA66
2. Rated voltage: 250V
3. Rated current: 20A
4. Stripping length: 12-13 mm
5. Stripping length range: 0.47 in
6. No danger of wire loosening and tape embrittlement, transparent and safe
7. With test holes, no need to remove the tape to measure the voltage
8. Direct insertion, wrong connection can be pulled out, repeated connection
9. Each contact shrapnel is independent, different wire diameter conductors are also available, safe short connection.
10. Permanent temperature resistance 105 Celsius degree, non-brittle
11. Maximum connectable 4mm/32A/400V
Connection method:
1. Stripping insulating skin of single core and strand 9-11 mm
2. Move the orange pressure bar up with your thumb and open the spring box.
3. Insert the wire through the spring box opening.
4. Press down the orange pressure bar and the wire will be clamped automatically.
Wire removal method:
1. The wire can be removed by moving the orange pressure bar upward with the thumb.
2. Rated voltage: 250V
3. Rated current: 20A
4. Stripping length: 12-13 mm
5. Stripping length range: 0.47 in
6. No danger of wire loosening and tape embrittlement, transparent and safe
7. With test holes, no need to remove the tape to measure the voltage
8. Direct insertion, wrong connection can be pulled out, repeated connection
9. Each contact shrapnel is independent, different wire diameter conductors are also available, safe short connection.
10. Permanent temperature resistance 105 Celsius degree, non-brittle
11. Maximum connectable 4mm/32A/400V
Connection method:
1. Stripping insulating skin of single core and strand 9-11 mm
2. Move the orange pressure bar up with your thumb and open the spring box.
3. Insert the wire through the spring box opening.
4. Press down the orange pressure bar and the wire will be clamped automatically.
Wire removal method:
1. The wire can be removed by moving the orange pressure bar upward with the thumb.