100/150Pcs Tile Leveling Floor Kit Alignment Clip Reusable Spacers Locator Kit (SET: SET1)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615088761
SELECTED OPTION:
SET: SET1
Description: 100/150Pcs Tile Leveling Floor Kit Alignment Clip Reusable Spacers Locator Kit ? Specification:? Material: High Quality PP + Stainless Steel Color: Black+Orange Applicable Brick Difference: 2-6mm / 0.08-0.24 Applicable Tile Thickness: 3-16mm / 0.12-0.63 Set 1: 100Pcs Set 2: 150Pcs ? Features: - Wear-resistant, recyclable, reusable. - Easy to use in DIY operation. - Balance tiles in the same horizontal position. - Improve tile installation speed. - Reduce installer fatigue / pressure. - There is virtually no crackless, flat surface. - This reduces the need for sharpening and polishing. - Avoid shingles from movement during solidification. ? Usage Tips: Lay the first tile, leaving more than 2mm (with cross joints). Close to tile. Insert T-pins next to the gap between the tiles. Then rotate 180 degrees and the T-needle is attached to the bottom of the two tiles. Adjust the cover by hand / special wrench until the two tiles are on the same level. After leveling for about 5-6 hours, before the cement / adhesive is completely dry, rotate the lid in reverse and take off the 180 degree T needle until the floor is removed. ? Avoid not removing the T-leveling tile system: 1. Ceramic tile joints are 2mm or more (cross joints are recommended) 2. When leveling, adhesive cement or tile cement around T-type leveler should be cleaned. 3. Remove the T-type straightener about 5-6 hours after leveling before the tile or cement binder is completely dried. ? Package Included: 100/150 x Tile Leveling System Floor Kit (Optional) ? More Details:
