This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1714
Similar products
10V-60V 30A Battery Control Module Over-discharge Protection Storage Battery Charging Controller Und
New
R491.00
Closed
11 May 24 00:05
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
612375080
Descriptions: ? This battery control module, features automatic charging, automatic power off, suitable for storage batteries and lithium batteries. Parameters is adjustable and can be saved in memory after power failure. ? Features: ? - Thick circuit board for long-lasting performance. - Easy to install and safe to use. - Parameters is adjustable and can be saved in memory after power failure. - Suitable for storage batteries and lithium batteries. - The battery is automatically charged and disconnected the load under the voltage, and the battery is discharged and connected the load over the voltage. ? Specification: ? Control Voltage: 10V-60V Control Current: 30A Control accuracy: 0.1V Voltage Deviation: ±0.1V Application: storage batteries and lithium batteries Size: Approx. 9.5 x 6 x 3.3cm Weight: 110g ? Product Settings: ? For example: Take 12V battery for example. Press S1 key until the digital tube flash to set the over-voltage is 14.4V. Press S2 key until the digital tube flash to set the under-voltage is 10.5V. When the battery is below 10.5V, the load should be disconnected after 6 seconds delay. If the battery voltage is restored to more than 10.5V in 6 seconds, the load will continue to work and the delay will be operated not properly due to the fluctuation of the battery voltage when the large current load is started. When the load is disconnected, the module is connected to the charger, and the load stops charging when the load is up to 14.4V. ? Note: When the under-voltage value cannot be increased, adjust the over-voltage value first. Connect battery first for the module is powered by the battery. ? Voltage Setting Method: ? S1 over-voltage: charging stop voltage or load start voltage At normal mode, press S1 button to show current over- voltage value. Press and hold S1 button till display flashes, then adjust over-voltage value by pressing S1 and S2 button. S2 under-voltage: charging start voltage or load stop voltage At normal mode, press S2 button to show current under- voltage value. Press and hold S2 button till display flashes, then adjust under-voltage value by pressing S1 and S2 button. At normal electricity mode, Press and hold S1 and S2 button till the digital tube display 888, then the original factory settings is completed successfully. ? Package Included: ? 1 x 10V-60V 30A Battery Control Module Over-discharge Protection Board
