12x60 Inch 3D Red Carbon Fiber Vinyl Car Wrap Roll Film Sticker Decal

Description:
12x60 Inch 3D Red Carbon Fiber Vinyl Car Wrap Roll Film Sticker Decal
Specification:
Material: vinyl
Color: Red
Quantity: 1 Piece
Surface finish: Carbon Fiber
Size: 152x30cm / 60"x12"  (Length x Wide)
Temperature resistance: -30°C to +130°C  
Placement on Vehicle:   Left, Right, Front, Rear
Model: for sheet wrap cover window film roll
Type: with air release channels, air bubble free
MPN: car sticker carbon fiber vinyl
Supper life time: Over 10 years indoor life, 3-5 years outdoor life
Condition:  Brand-new, unused, unopened, undamaged item in its original packaging
Features:
It is a self adhesive vinyl Material, its function is same as 3M carbon fiber vinyl, excellent quality.
Self-adhesive backing with Air Release Channels (Bubble-Free).
Can be re-lifted, repositioned, and it brings you fast and easy installation experience.
Easily removable, and will NOT damage to your paint during or after installation.
Completely waterproof, stain and UV resistant.
Ultra thin for easy installation on curves and corners.
It is widely used for Car, Laptop, Motor, trunk lids, Home Decoration, side pillars, Bike, Phone, etc.
Paste instructions:
[Dry paste method] applicable motorcycle sticker  or small stickers
[Dry paste method steps]
Tools: clean cloth, scraper, credit card
1, Clean body paste location. You can use isopropyl alcohol or acetone to scrub, or also can use soapy water; after cleaning surface Volatilization then can paste.
2, In General, while stickers, while tools evenness.
3, If the car stickers are less than 10 cm length and width, you can put the sticker tear paste.
4, With a clean rag or scraping (such as phone cards or credit cards) in the film repeatedly forced to rub or scrape a few oblique; until no bubble, then ripped (transparent) transfer film; Proposal: Do not wash or exposure within 24 hours.
[Wet paste method] applicable  large automotive car stickers[recommend Double people Operation]
[Wet paste method steps]
Tools: watering can, a clean rag, scraper, utility knife, hairdryer
1, Clean the surface paste, sprayed water on the paste surface
- Is mainly used to reduce the sticker viscosity, easy to adjust the position.
2, Determine the location of the need stickers, together with car stickers from right to left (or from the bottom to up) use rag pressed posted on the car, then while stickers, while flatten with a rag,
4, Timely adjusted, when determine the correct location. Repeatedly with a scraper scrape water and bubbles, scraped from right to left  when using the scraper.
5, At the door, and sewn use Utility Knife cut open,
6, Try to make car stickers in the water dry, can moderate heating and drying with a hairdryer. Suggestion: Try not to exposure within 24 hours, do not wash within 48 hours
Installation process:
                Clean vehicle body                       Remove part of the whole car stickers,
                                                                        according to the models may be
Does not matter if the sticker  fold,          Slowly calibrating the blade,repeat
    proper stretching,hair dryer heating                   the operation
Encountered arc, bend area with              Special attention to corners, this it
               a hair dryer heating                       more difficult to stickers, it can
                                                                               test your patience
     Paste process                                        Corners heating, proper stretching,<