1CH Channel DC5V 70MA Latching Relay Module Bistable
New
Indicative market price: R89.19
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Henley on Klip, Meyerton
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Tuesday, 21 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
1930
Bob Shop ID
613700946
Bistable relays are used to switch electrical circuits by impulse command, especially for lighting control in ordinary applications.
Reduce power consumption over extended duration's. A latching relay is a two-position electrically actuated switch that maintains either contact position indefinitely without any power being sent to the coil and is a perfect choice to reduce the power consumption of a system.
Specifications
USE 1:
By default, the relay is released, press the trigger button, the relay pull, press again, the relay release, the third press, the relay pull, and so on.
USE 2:
By default, the relay is released, MCU output low-pulse(0.3-1seconds), the relay pull, low-pulse again, the relay release, the third low-pulse, the relay pull, and so on.
Module interface
1. VCC: positive power supply (VCC)
2. GND: negative power supply (GND)
3. T: Low pulse trigger (Ground the pin to trigger the relay)
Relay outputs
1. NO: normally open relay interface
2. COM: Common Interface Relays
3. NC: normally closed relay interface
Typical applications
What's in the box?
1 x Relay module Note: Stock is currently available in South Africa for national shipping!
Reduce power consumption over extended duration's. A latching relay is a two-position electrically actuated switch that maintains either contact position indefinitely without any power being sent to the coil and is a perfect choice to reduce the power consumption of a system.
Specifications
- Working voltage: DC 5V(This relay is NOT 3.3V compatible)
- Working current: 70MA
- Standby current: 1UA
- Load current: AC 250V / 10A, DC 30V / 10A
- Trigger mode: Low pulse trigger
- Size: 35mm x 16mm x 18.5mm
- Weight: 13.5 g
USE 1:
By default, the relay is released, press the trigger button, the relay pull, press again, the relay release, the third press, the relay pull, and so on.
USE 2:
By default, the relay is released, MCU output low-pulse(0.3-1seconds), the relay pull, low-pulse again, the relay release, the third low-pulse, the relay pull, and so on.
Module interface
1. VCC: positive power supply (VCC)
2. GND: negative power supply (GND)
3. T: Low pulse trigger (Ground the pin to trigger the relay)
Relay outputs
1. NO: normally open relay interface
2. COM: Common Interface Relays
3. NC: normally closed relay interface
Typical applications
- Automotive electronics
- Motor
- LED
- Smart Home
- Emergency lighting
- MCU development board
- Toy car
What's in the box?
1 x Relay module Note: Stock is currently available in South Africa for national shipping!