1m 3D Touch Bed Automatically Level Sensor Print Compensation Sensor
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0603654401
Bob Shop ID
593632737
1. The 3D Touch automatic leveling sensor is a device that uses the Hall effect to achieve leveling
2. The position of the point can be obtained by touching the point on the heating bed, and then compensated by adjusting the Z-axis height during printing, so that printing can be realized even when the platform is uneven
3. Rated current: 300mA
4. Shell material: PC
5. Voltage: 5V
6. Current: 15mA
Shipping list:
-1 x 20cm wire
-1 x 1/1.5m wire
-1 x Sensor
-1 x Wound terminal
-1 x XH2.542pin terminal
-1 x XH2.543pin terminal
-2 x M3 nuts/nails