2.0mm 1.5m Desoldering Braided Solder Remover Wick

2.0mm 1.5m Desoldering Braided Solder Remover Wick

New 13 available
Indicative market price: R48.97
R44.52
Shipping
R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Seller
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
South Africa
Product code
1310
Bob Shop ID
613701021
Desoldering braid or "wick" is a pre-fluxed copper braid that is used to remove solder, which allows components to be replaced and excess solder (e.g. bridging) to be removed.

Specifications

  • Type : CP-2015
  • Length : 1.5M
  • Width : 2.0mm

What's in the box?
 
1 x 2.0mm 1.5m Desoldering Wick CP-2015

Resources

How to desolder

How to use

1.Place the desoldering wick over the solder to be removed,then put the heated soldering iron tip onto the desoldering wick.The solder will be absorbed.
2.Remove the desoldering wick after the solder has been absorbed.
3.Cut off the used section of the wick using nippers.
4.Repeat steps 1,2 and 3 if the solder is not removed completely.
Absorption may differ depending on the type of solder.Sn63% and 60% (tin content) have good absorption ability.
Note: Stock is currently available in South Africa for national shipping!
Add to cart

Similar products