This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1650
Similar products
2.7A 1S Dual Way Micro Brush ESC 3.3-6V Winch Reversing with Overheat Out of Con... (MODE: WITHWIRE)
New
R449.00
Closed
11 May 24 00:18
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612425305
SELECTED OPTION:
MODE: WITHWIRE
Description:
Item Name: Electronic Speed Controller
Model: Brushed
Current: 3.3V-6V, long-distance running 2.7A, peak 10A
Size: 20x9mm
Weight: 2g
Usage: suitable for modeling Car, changing toys, intelligent building blocks, etc.
Features:
-Start with the neutral point (when the power is on, you will hear the motor beep prompt, throttle channel 1500 (+/-50), you will hear the motor beep down, the ESC starts, the motor prompts the ESC to the motor small current And issued, for a motor that is too easy to turn, the motor will turn twice, no surprise.)
-Oil range PWM 700-2300us wide range adaptation
-With out of control protection Loss signal (in the accident, the signal line is broken) The motor stops. (If you connect the signal line with power, please return to the midpoint to restart)
-The ESC has overheat protection. If the ESC temperature exceeds 150 degrees, the motor output stops, the temperature drops to 130 degrees, and the output is re-output.
-(There is optimization of the hollow cup, the initial duty cycle can be adjusted small)
-The original receiver takes power: you can change the battery cable.?
Receiver power requirements:
-Use the other 2/3S ESC to power the receiver. When plugging the receiver into the receiver, the load should not exceed the received power supply capacity (bec is usually 1A, except for the receiver, etc., only hundreds of milliamps are available)
-Of course, in the case of 1S, you can reverse the process, add a battery cable to the ESC, and then use the ESC 3P to receive the power supply (1S lithium battery is available for the receiver)
Package Included:
1 x ESC
