2 Channel Angle Tilt Sensor Module 3.3V-5V - Arduino

New

Shipping

Standard courier shipping from R60

R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate

Ready to ship in

The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Buyer Protection How you're covered

Get it now, pay later

Product information

Condition:

New

Location:

South Africa

Product code:

520

Bob Shop ID:

612190845

2 Channel Angle Tilt Sensor Module 3.3V-5V - Arduino

Product Description

^{SW-520D high sensitive tilt sensor}

^{The comparator output signal waveform, clean, good, strong drive ability, more than 15mA.}

^{A sensitivity adjustment potentiometer}

^{Working voltage of 3.3V-12V}

^{Output mode: digital switching output (0 and 1)}

^{A fixed bolt hole, convenient installation}

^{Small size: 3.2cm x 1.7cm PCB}

^{Wide voltage comparator LM393}

Product Features

From the initial state of the two output depends on the tilt sensor conduction disconnect, when turned on, the green light, the output low, tilt sensor disconnected, the green light is off, output is high;

Inclination sensor generally in the initial state are installed in the normally open state, so that the inclination sensor is not in a working state, to prolong life;