2 In 1 Air Fuel Ratio Gauge Voltmeter 12v 52mm Digital Afr Volt Meter
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613498863
Working Voltage: DC12VSignal Line Voltage: 0-1VSpiral: M18 x 1.5Use Wrench: 22mmOutput Voltage: Maximum value greater than equal 900mv/ minimum value less than equal 50mv.How to Connect the Gauge to Sensor:The white line is at heater abBlack line signal line C, gray line signal ground DThe green wire of the instrument is connected with the black wire of the sensor. The gray line is connected to the negative pole of the battery.One white wire connect with the car shell or battery negative pole.Another white wire connect to the ACC line of ignition switchThe white line is the heater and does not distinguish between positive and negative electrodesResponse time: (600mV-300mV) less than equal 100ms.Response time: (300mV -600mV) less than equal 100ms.Starting time: less than equal 10sHeating resistance: 8.5-9.5ohmInternal resistance: 200-300ohmcolour:Black+whiteMaterial:plasticPackage Contents:1 x Air Fuel Ratio Gauge1 x Cable1 x O2 Oxygen Sensor1 x English manualOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.