2 Pcs 90 Degree Right Angle Power Board for Motherboard (up Angled)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
613375248
[Solution]Providing a convenient solution for changing the installing direction of USB 3.0 20 pin/19 pin cables with the 90-degree L-Turn DOWN Angled adapter.By allowing the USB 3.0 20 pin/19 pin cable to be installed at a 90 degree angle, builders are no longer need to wrap or fold the cable up and back over the motherboard and reduce the amount of cables needed in front of the motherboard tray.;[Compatibility]The adapter is standard USB 3.0 20 pin connector, so it will work with all of USB 3.0 20 pin/19 pin ports on the motherboard such as Gigabyte Msi Onda Inte DELL HP Lenovo USB3 Motherboard, etc.;[Note]The adapter was only designed for USB 3.0 20 pin/19 pin port to improve the connection between your motherboard and USB 3.0 20 pin cable. Must install the adapter step by step to avoid shorting pins and motherboard damage. Please remove power cable and wait 10 seconds before installation.;Material:PC+metalcolour:Black+BluePackage Contents:2 * USB 3.0 20 Pin Male to Female 90UP Angled AdapterOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.