2 PCS Car 45mm Oxygen Sensor Adapter Oxygen Extension Modified Connector M18x1.5
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
EDA0013305
Bob Shop ID
593633194
1. These are needed when using a HHO System or a test pipe.They are also used to lean out your vechicle for better gas milage.
2. The extender has a 7/8 hex head which is the same size as most O2 sensors and it makes them easer to install not like the straight sided extenders.
3. Fits all standard size sensors with a 1/2 Inch diameter tip.The size of the extenders is M18 X 1.50mm.
4. They are very easy to install by unscrewing your O2 Sensor from your exhaust then screw your sensor into the extender,and then screw the two pieces back into your exhaust.
5. Material: iron
2. The extender has a 7/8 hex head which is the same size as most O2 sensors and it makes them easer to install not like the straight sided extenders.
3. Fits all standard size sensors with a 1/2 Inch diameter tip.The size of the extenders is M18 X 1.50mm.
4. They are very easy to install by unscrewing your O2 Sensor from your exhaust then screw your sensor into the extender,and then screw the two pieces back into your exhaust.
5. Material: iron