This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by techietoys118
Similar products
2 PCS DC 12V Car License Plate Anti Photo Radar Device
New
R2,289.00
Closed
6 Jun 24 23:03
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
S-CMS-1605
Bob Shop ID
614656861
2 PCS DC 12V Car License Plate Anti Photo Radar Device
Overview
When you drive overspeed or run the red light unwittingly, to be taken picture by car radar camera, you have to pay the police penalty and waste your time. If you have a Car Radar Resister, you do not need to pay this money! This device will protect you from Violation Ticket. And also remind you drive complying with the traffic regulation. This device is hidden installed, not easy to be discovered. This device supports continuous flashing, can jam all kinds of digital cameras.
Installation instructions
1. Each license plate has four screw holes, remove the license plate below the two screws, anti-shoot cards into the screw holes with glue fixed
2. First anti-film, and Junction Boxes separation, the signal cable through the boot of the license plate light hole successor
3. Found in the boot line of the signal line and the junction box connection (must be connected according to color), otherwise it will affect the product functionality
4. Junction box to find a suitable location to the fixed. Connect the power supply (12V), Complete the installation
5. Start the car engine, the device is powered, the indicator lights on the junction box to prove the equipment is functioning properly
6. Test equipment; Open the flash of the product with a camera to shoot, the effect is very amazing
7. Two modes: A is slow flash mode, B is fast flash mode
Note: Life is precious, safety importance electronic camera ban challenge laser radar equipment, which; My company does not assume the resulting all relevant obligations and joint responsibility.