2 PCS HW-134A A4988 Red Board Stepper Motor Driver Module Heat Sink for 3D Printer
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD05721763
Bob Shop ID
614660896
2 PCS HW-134A A4988 Red Board Stepper Motor Driver Module Heat Sink for 3D Printer
1. Features: Higher copper content, good heat dissipation performance, strong current stability
2. Manufacturing process: SMT placement machine manufacturing, non-manual welding, higher yield rate, more stable performance
Remarks:
1. A single-head printer requires 4 A4988 modules.
2. A set of dual-nozzle printer requires 5 A4988 modules.
4. Delivery list: A4988 module x 1, heat sink aluminum sheet x 1
5. Matters needing attention: Please do not plug and unplug the motor and drive when the power is on, which will easily cause the drive to burn out; also do not adjust the current when the motor is running. The correct way is to first disconnect the power supply, unplug the motor, and then power on again, adjust the potentiometer, and measure the voltage on the potentiometer until the measured voltage is the same as expected. Do not plug in the reverse drive, otherwise it will burn out the drive and even the motherboard