2 PCS/Set 3D Printer Heated Bed Power Expansion Module MOSFET Board for ANET A8 3D Printer
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0599532601
Bob Shop ID
614584840
2 PCS/Set 3D Printer Heated Bed Power Expansion Module MOSFET Board for ANET A8 3D Printer
1. The hot bed high-power expansion module has a compact appearance and stronger heat dissipation, which can solve the problem of excessive heating bed power and current load.
2. Under normal heat dissipation, this module can work stably for a long time when the measured I (Max) is equal to 30A. During use, the current should not exceed 30A.
3. When using a hot bed with a power greater than 150W, please connect an external high-power module
4. Easy to use
5. Delivery list: high-power module, motherboard PWM 20CM signal control line, high-power module 30cm power supply wiring (2 red and black)