2 Ports + HD-AUDIO USB 3.0 Front Panel Data Hub
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
PC16621
Bob Shop ID
593634352
1. Transmission rate: 5Gbps
2. Backward compatible with USB2.0 and 1.1 versions
3. USB3.0 is a full-duplex, four-way differential signal independent of the USB 2.0 signal, and supports simultaneous two-way data transmission
4. Support WINDOWS2003/2007/XP/Vista/WIN7/WIN8, support plug and play, support hot swap
5. Higher power, faster charging, easy to drive related equipment
6. Use this device to directly convert the 20PIN interface and audio on the board into 2 USB3.0 interfaces, headphone output and microphone interface, and install them in an idle floppy drive position. This provides a front USB interface and audio interface.
7. Hardware requirements: with a 20PIN USB3.0 interface and a motherboard or adapter card that supports HD-AUDIO audio, and a chassis with a free floppy drive
2. Backward compatible with USB2.0 and 1.1 versions
3. USB3.0 is a full-duplex, four-way differential signal independent of the USB 2.0 signal, and supports simultaneous two-way data transmission
4. Support WINDOWS2003/2007/XP/Vista/WIN7/WIN8, support plug and play, support hot swap
5. Higher power, faster charging, easy to drive related equipment
6. Use this device to directly convert the 20PIN interface and audio on the board into 2 USB3.0 interfaces, headphone output and microphone interface, and install them in an idle floppy drive position. This provides a front USB interface and audio interface.
7. Hardware requirements: with a 20PIN USB3.0 interface and a motherboard or adapter card that supports HD-AUDIO audio, and a chassis with a free floppy drive