Description:
Up to 6 pcs can be posted at the 1kg rates given below
Buy 6pcs and get FREE postage!
Â
- Programming timer is a simple and quick procedure
- Switches loads up to 3000 Watts (16 Amps)
- Time duration of the required working time can be set by pushing the joint slices
- Real time can be set by turning the disc in the direction of the arrow until the marked point indicates the current time
- Ideal for swimming pools and lighting
Â
Operating Instructions MTD4
1.)
MOUNTING INSTRUCTIONS
Safety Information: Electrical devices should only be connected and mounted by an electrical specialist. Manipulations and Modifications on the switch will result in loss of warranty. The national specifications and applicable safety regulation must be observed.
The quarts movement starts automatically after a few minutes once the timer has been connected to an ac power supply of 230 Volt/ 45 - 60 Hz AC. The full power reserve is built up after about 3 days but the timer, once connected can be set up and used immediately.
Setting the time. Programming the timer.
Press down the blue slices at the time intervals you want the timer to switch on. Keep in Mind each blue slice represents half an hour and every little line between each number
l I l represents half an hour. (1, 1½, 2 etc.) Move the button at the bottom left corner to auto. The timer should work as required. Overriding the Timer. Turning your timer on or Off Manually.
To switch the timer on or off in the Perm position at any time desired use the On / Off Control to force the unit to turn on or off.
EMV/CEN/EMC/ETY
( The button in the left hand bottom corner has to bee on PERM)
The time switch has been build in accordance with European directives 73/23/EEC (Low Voltage Directive) and 89/336/ EEC ( EMC - Directive). If the time switches are used together with other devices in an installation, take care that the complete installation does not cause radio interference.
Â
Â
Â
Â
Â
Â
WIRING DIAGRAM
Â
2.)
Â
You have to set the timer using the Pointer (Black Diamond Shape) as reference by turning the Dial Knob clockwise until the corresponding number (Current time) falls under the pointer.
You can set the seconds as well. The seconds run in sequence from 0 at intervals of 5 seconds to 60.
Â
4.)
Â
5.)
Â
If the timer has switched on and you would like to keep it on without changing any of your settings move the button in the bottom left hand corner to the PERM position. This means, keep the unit on permanently.
When no longer required to stay on, move the button back to Auto to revert to your normal programmed times. ( The unit will carry on using your settings as previously programmed)
If the timer has switched off and you would like to keep it of without changing any of your settings move the button in the bottom left hand corner to the PERM position again . This means, keep the unit off permanently.
When no longer required to stay off, move the button back to Auto to revert to your normal programmed times. ( The unit will carry on using your settings as previously programmed).
6.)
