24V 36V 48V 60V BMS 6-20S 50A 80A 120A 150A 3.2V LifePo4 Battery Protection Board ... (CURRENT: 50A)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615102692
SELECTED OPTION:
CURRENT: 50A
1. The current of the selected protection board is different, the number or model of the MOS tube on the board is different, the actual product shall prevail 2. For batteries with different numbers of strings, you only need to short-circuit the cable from B+ to the number of strings you need. 3. Do not insert the flat wire into the terminal before connecting the protection board, remember! Wrong cable connection will burn the protection board! 4. Connect the ribbon cable and the battery in order, check that the adjacent voltage is correct, and then insert the ribbon cable; then use a short and thick wire to connect to B-, and then to C-(P-). 5. Please install the protection board close to the negative pole of the battery. The wire connecting B- should be as short and thick as possible, and the length should be controlled within 10cm. It is recommended that the 50A version use 4 square wires and the 80A version use 6 square wires. The B- connection is too long or too thin will cause a series of problems such as failure to start, power failure during operation and so on.
Features:
The board adopts mature protection circuit, original dedicated protection IC, 100A high current low internal resistance MOS (single MOS internal resistance as low as 4.2 milliohms), with perfect and stable charging and discharging protection functions. Small size and large current can be used in large current occasions such as electric tools, electric vehicles, UPS, etc.
| Electric?vehicle?type | Motor?wattage | Recommended?protection?board | |
| Two-wheel?electric?vehicle | 500-800W | 50A | |
| 800-1000W | 80A | ||
| ???1000W | 120A | ||
| Three-wheeled?electric?vehicle | ordinary | 800-1000W | 80A |
| ???1000W | 120A | ||
| Cargo | 120A/150A | ||
| Four-wheel?electric?vehicle | 120A/150A | ||
Package Included:
1x BMS 6-20S 50A 80A 120A 150A 3.7V Li-ion Battery Protection Board?Common Port Version
