25 Pcs Plastic Push In Car Bumper Fender Door Rivets Clip 10mm Hole
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
616123822
2 set Auto parts: 1 set x Hood release Handle & 25 x Plastic RivetThis fits all models of the for Honda Civic from 1996 to 2011, for Honda CR-V from 1997 to 2006, for Honda the Ridgeline from 2006 to 2014.This replacement hood release latch is a repair for the plastic latch which will often crack and break off the end of the cable. This can be installed in 5 to 10 minutes.This sale is NOT for the entire cable, just for the replacement latch handle that fits on the end of the cable.Color: black;Material: aluminum+PlasticPlastic Rivet: Product Name: Clips/Rivets/Fastener; Fit Hole Size: 10mm/0.4inchHead Diameter(max.): 20mm/0.8inch; Stem Length: 17mm/0.6inch; Total Length: 26mm/1inchQuantity: 25; Interchange Part Number: Under Engine Splash Guard Rivet Fastener Clips; Manufacturer Part Number: Plastic Push-Type Bumper Retainer ClipOther Part Number: Screw Fender Body Door Trim Panel Hood; Applications: Defender Door Card Interior Weatherstrip Moulding;Hood release Handle: These rivet fasteners are made of plastic material, suitable for car use.Car good accessory, commonly used for fitting side skirts, bumpers and other trim.These clips are suitable for firmly holding anything within a fit diameter hole.They can be used on buses, trains, planes, truck, caravans and car.Machined from a solid block of aluminum.The normal cable replacement would take between 1-1/2 and 2 hours. This replacement latch can be installed in a few minutes. It requires the removal of the corner plastic kick plate. Then about 1inch of the remaining plastic must be trimmed off the end of the cable with wire cutters. (See photo.) Slip it over the end of the cable, tighten the 2 set screws, replace the corner plastic kick plate, and you are finished.Package Contents:1 x Hood release Handle1 x Hex key1 set x screw25 x Plastic RivetOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.