2pcs Carbon Brush Motor for Dremel 3000 200 Brush Repairing Part
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613371820
Replace it every 60 hours, otherwise the electric rotating tool will overheat.Carbon brush, suitable for Dremel carbon brush, used for dremel electric knife sharpening tool 3000,200.installation method:Step 1: Use a wrench to open the carbon brush cover.Step 2: Take out the carbon brush.Step 3: Replace the carbon brush with a new one.Step 4: Use a wrench to lock the lid firmly.Note: These brushes should be replaced every 60 hours.Size: about 4.8x4.8x10mmApplication: Suitable for Dremel 3000, 200.Colour:Photo ColorMaterial:carbon + metalPackage Contents:2 x Carbon BrushesOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.