2Pcs Carbon Front Fog Light Fog Lamp Eyebrow Cover Trim For VW Golf 7 MK7 2014-2017

New

20 available

R1,517.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3804

92.88 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Condition

New

Location

International

Bob Shop ID

648349987

.size_table_start table,.size_table_start table tr td { border:2px solid #ddd;}.size_table_start table { width: 100%; min-height: 25px; line-height: 25px; text-align: center; border-collapse: collapse;}.size_table_start,.size_table_end {clear:both;}

Specification:
Material: High Quality ABS Plastic
Color: Carbon Fiber Look
lacement on Vehicle:Left, Right, Front

Fitment:
-For VW Golf MK7 2014- 2017
-Only for Standard MK7,
-NOT for any GTI , GTD, R models

Features::
-Easy installed and No modification needed.
-Correct Connector No cutting or splicing.
-Strict quality control standards to Build and test.
-Improves Appearance and Dynamic All at Once.

Package Included:
2 x Front Fog Lamp Eyebrow Wind Knife

Installation method:
1. Clean the location of the installation with rubbing alcohol before proceeding. (make sure to remove any grease, wax or dust etc)
2. Please ensure that the product completely fits before proceeding with installation. (Note: if there any questions or if the product does not fit properly, please contact us)
3. Remove the high strength double-sided adhesive from the back of the plate. In the case of a relatively low temperature, heat installation location, and plate with a hair dryer or a heat tool on low setting
4. Carefully place the product in desired location and press down for about 1-2 minutes, (Note: do not wash your car for 24-hours. The adhesive should be cured after 12-hours)
5. The installation is complete