R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable. Check my rate
The seller has indicated that they will usually have this item
ready to ship within 12 business days.
Shipping time depends on your delivery address.
The most accurate delivery time will be calculated at checkout,
but in general, the following shipping times apply:
Replacement Guarantee:
7 Days: We stand by this guarantee
Get it now, pay later
Product details
Condition
New
Location
International
Bob Shop ID
640910826
The L3+ U73 power step-down module can be used for L3+ 10V step-down circuit control, on the computing power board with no material, serious oxidation, and lack of material.The module has a total of 8 external solder joints, 4 solder joints do not need soldering wires, and can be connected to 3 external wires (the PIC cannot adjust the voltage) or 4 external wires (the PIC can adjust the voltage).1. GND: The negative pole of the power supply is grounded2. 12V: 12V input3. EN: power-on signal, connected to pin 3 of Q104. HG: controlled by the upper MOS tube, connected to the 4th pin of the MOS tube5. LG: controlled by the lower MOS tube, connected to the 4th pin of the MOS tube6. DAOUT: connect to PIC, can accept PIC voltage regulation7. FB(mos): Feedback input, connected to the large inductor L2, close to the MOS end8. SW(out): connect to the output of the large inductor L2Type: Power Supply Step-down BoardOutput voltage:10VInput voltage: 12VCompatibility: for Antminer L3+color:GreenMaterial:PCB board + electronic componentsPackage Contents:2 x 10V Power Supply Step-down BoardOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.