Fast heating: built-in thermostat, and the heating time is only 30 minutesSafety: double overheat protection, the heater is safePremium : metal casing for service life, no less than 2000 hours.Wide applications: Suitable for all types of with an engine displacement of 1.8 liters, such as , trucks, buses, motor homes, trucks, campers, caravans, construction vehicles, boats, etc., enjoying the warmth in the cold winter.Multiple functions: It can heat source for the car, the temperature inside the car, and preheat the engine coolant to avoid the engine wear at low temperature. Conducive to car interior thawing, car , car glass fog defrosting.Reduce the cost of fuel consumption and winter warm library.Eliminating the difficult after the winter parking troubles.Even at 30 degrees over the cold, also can reach the , to travel purposes.Installation and Warning:After installation, must be anti-antifreeze exhaust, so as to avoid air in the antifreeze air resistance, antifreeze does not lead to damage to the preheaterNatural heater can not use this preheater, the preheater can only be used for the use of high-quality glycol antifreeze vehicles, low-grade antifreeze will scale, rust and ice, plug the preheater. use the rated voltage of 220-240 volts, 10A power socket and can carry the power of 16A international three-wire, and a grounding protection power.Working principle: The preheater uses a 220V power supply to circulate and heat the antifreeze through a built-in pump and electric heating to the engine temperature.Name: Automotive PreheaterPower: 3000 Applicable voltage: 220V-240VAutomatic temperature control: 65C-70CPump lift: 90CM \/ 35.4 inches or moreApplicable models: Suitable for with engine displacement (1.8-2.5L)Plug Type: EU Plug,it applies to Indonesia, , , , and so oncolor:Photo color:MetalPackage Contents:1 x Heater PreheaterOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +\/- 1-3cm.
