36V 350W XT30 Motor Controller+Dashboard For Scooter Electric Bicycle E-bike

.size_table_start table,.size_table_start table tr td { border:2px solid #ddd;}.size_table_start table { width: 100%; min-height: 25px; line-height: 25px; text-align: center; border-collapse: collapse;}.size_table_start,.size_table_end {clear:both;}

Note:

?This?controller?is?the?replacement?parts?for?? ,if?you?don`t?have?ID:?1647907 ,you?should?not?buy?it

???

Specification:

Voltage	DC 36V
Rated Power	350W
Undervoltage	30V
Current-Limiting	8.8A

Instruction:

1. Boot: Long press the boot (about 1s). At the same time, the buzzer sounds twice.

2. Shutdown: Press and hold 3s to shut down. At the same time, the buzzer sounds twice.

3. Light: In the power-on state, short press (within 1 second) once, turn on the front and rear lights,

the headlights are always on, and the taillights are flashing.

4. Brake: Electronic brake + disc brakes. The tail light is long on the brakes.

5. Gear shift: The power-on state, the default is the low-speed file;

press the button twice (press twice in one second) to switch the gear position; Green is low gear; red is high gear

6. Battery display: 33v-36v The first light is long

36v-37v one or two lights long bright

37v-38.5v one or two lights long bright

38.5v or more, one, two, three, four lights

Low voltage alarm: The first light flashes when the battery is below 33V, and the buzzer sounds 6 times.

7. Low voltage alarm speed mode: The speed limit is about 15Km/h. When the power returns to 37V,

the throttle must return to the initial position to release the low voltage and return to normal operation.

8. Constant speed cruise: The speed is stable for about 6 seconds to automatically start the cruise control;

after the cruise is fixed, the throttle can be released; press the brake

or push the throttle again to release the cruise control and enter the manual mode.

9. Speed: The low speed gear is 15±2km/h; the high speed gear is 25±2km/h.

10.Automatic shutdown: Automatically shut down 10 minutes after no operation.

Error Code:

1) E1 Motor Hall failure

2) E2 MOS

MOS fault or motor phase line short circuit fault

3) E3 Brake failure

4) E4 Handlebar failure

5) E5 Undervoltage protection

6) E6 Instrument/control communication failure

7) E7 Overvoltage protection

8) E8 Controller op amp failure

9) E9 Stall protection

?

Package Included:

1 X?	Controller
1 X?	Dashboard