3d Cnc Shield Board+a4988 Stepper Motor Driver for Arduino 3d Printer
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613457640
CNC Shield Board: Latest CNC Shield Version 3.0 for Arduino.GRBL 0.9 compatible. (Open source firmware that runs on an UNO for Arduino that turns G-code commands into stepper signals).PWM Spindle and direction pins.4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13).2 x End stops for each axis (6 in total)Coolant enable,Uses removable A4988 or DRV8825 compatible stepper driversJumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping ).Compact design.Stepper Motors can be connected with 4 pin molex connectors or soldered in place.Runs on 12-36V DC. (At the moment only the DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board.),Please note that this is an unassembled kit and Basic soldering skills are needed.A4988 Stepper Motor Driver Board is a breakout board for Allegro's A4988 DMOS Micro-stepping Driver with Translator and Overcurrent Protection; please read the A4988 datasheet carefully before using this product.Low RDS (On) Output,Automatic current decay mode detection / selection,Mix with slow current decay modes.Synchronous rectification for low power dissipation,Internal UVLO.Crossover-current protection,3.3 and 5 V compatible logic supply,Thermal shutdown circuitry,Ground fault protection,Load short-circuit protection,Five selectable step modes: full, 1/2, 1/4, 1/8 and 1/16.Colour: Photo ColorMaterial: PC+ metalWarning: Connecting or disconnecting a stepper motor while the driver is powered can destroy the driver. (More generally, rewiring anything while it is powered is asking for trouble).Note: Green or Red PCBPackage Includes:2 x CNC Shield Board8 x A4988 Stepper Motor Driver8 x Heat SinkOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.