3D Printer LCD Panel Adapter for RAMPS-FD
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
CA1704
Bob Shop ID
602483083
1. LCD-Panel-adapter-FD is an adapter for Adruino DUE and Ramps-FD, which are always combined to work as a 3D printer control board.
2. As the operating voltage of the Arduino DUE chip is 3.3v, while the LCD display works best at 5V, we add a signal amplification circuit in chip of the adapter, so that the DUE board can better drive and isolate the LCD display.
3. LCD-Panel-adapter-FD is considered to be one of the best LCD adapters for DUE+ Ramps-FD on the market.
2. As the operating voltage of the Arduino DUE chip is 3.3v, while the LCD display works best at 5V, we add a signal amplification circuit in chip of the adapter, so that the DUE board can better drive and isolate the LCD display.
3. LCD-Panel-adapter-FD is considered to be one of the best LCD adapters for DUE+ Ramps-FD on the market.