3D Printer Stepstick Drv8825 Stepper Motor Driver replace A4988
New
6 were available
Indicative market price:
R46.72
R42.47
9% off
Shipping
R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable. Check my rate
The seller has indicated that they will usually have this item
ready to ship within 2 business days.
Shipping time depends on your delivery address.
The most accurate delivery time will be calculated at checkout,
but in general, the following shipping times apply:
1 simple steps and direction control interface 2 six different steps resolutions: full step, half step, 1/4-step1/8-step1/16-step, 1/32-step 3.CAN interface directly with 3.3 V and 5 V systems 4 Over-temperature thermal shutdown, overcurrent shutdown, undervoltage lockout 5 short to ground short circuit load protection 6.4 Layer 2 oz copper PCB, in order to improve heat dissipation 7 exposed solder ground below the bottom of the driver IC on the printed circuit board pad 8 module size, pin and interface matching A4988 stepper motor driver operators in many ways 9 adjustable current control lets you set a potentiometer, which lets you use the stepper motor's rated voltage or more, in order to achieve a higher rate of maximum output current step 10 Intelligent chopping control automatically selects the correct current decay mode (fast decay or slow decay) 11 Maximum 45 V supply voltage 12 built-in voltage regulator (the need for any external logic supply voltage)
How to control a stepper motor with ArduinoNote: Stock is currently available in South Africa for national shipping!
