3pcs AT42QT1070 5-Pad 5 Key Capacitive Touch Screen Sensor Module Board DC 1.8 to 5.5V Power For Sta
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615104881
Features: ? This board is the simplest way to create a project with multiple capacitive touch sensors. No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed. (Note that one contact will be detected at once (this is to protect against having a hand brush against two or more contacts at once.) The datasheet has many details on sensitivity, power usage, etc. - note that this board uses the chip in 'standalone' mode, it cannot be used in I2C mode. ? Specification: ? Model: AT42QT1070 Type: 5-Pad Capacitive Touch Sensor? ? Package includes: ? 3 x Capacitive Touch Sensor Board
