This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1674
Similar products
3pcs Voltage Frequency Converter 0-10V To 0-10KHz Conversion Module 0-10V to 0-10KHZ Frequency Modul
New
R482.00
Closed
11 May 24 00:07
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
612381879
Overview: ? The voltage to frequency module LM331_V2F is a module that can generate different frequencies depending on the input voltage. It is capable of converting 0-10V voltage into a frequency pulse signal of 0-10KHz. ? Features: ? 1. Input voltage, output frequency signal. 2. The output signal can be fine-tuned, and the potentiometer can be adjusted to calibrate the correspondence between voltage and frequency. 3. The output of this module can be supplied to the driver for pulse signal. It must be connected to the driver for common anode connection. The relevant wiring is OC-OUT: PUL- or PUL12-30V connected to the driver: PUL+ or common terminal +5V connected to the driver, ( When powering 12V, it is necessary to string a 330R resistor. When powering 13-24V, it is necessary to string a 2.7K resistor to limit the current) ? Technical Parameters: ? Working voltage: 13.5V-30V. Input controllable voltage range: 0-10V. Output frequency range: 0-10KHz. ? Wiring Instructions: ? VCC: Working power supply. GND: Power ground. IN+: Input voltage. IN-: Input ground. OCOUT: Signal collector output port (use this output port when equipped with a driver). FOUT: Frequency output port (common frequency output port). Two independent outputs, OC-OUT is NPN and FREQ-OUT is IC output. The common cathode end is matched with the negative GND of the power supply. When the common anode wiring is used with the power supply, when the common anode wiring is 13-24V, it is necessary to string a 2.7KR resistor, and the common anode wiring is 12V power supply. To string a 330R resistor. ? Instructions: ? The frequency pulse signal is connected to F, and there is a corresponding voltage output at the VOUT terminal. Input and output correspondence: 1V = 1KHz 10V = 10KHz If there is a deviation in the correspondence when using, you can adjust the potentiometer on the board to calibrate. ? Package Included: ? 3 x Voltage to Frequency Module LM331_V2F
