4' 100mm polishing bonnet wool
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Observatory, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Thursday, 2 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
MM4
Bob Shop ID:
609728639
Tie on polishing wool buff
Diameter: 100mm
Application:
The polishing wool buff should be used with an automotive polisher.
Different polishes and waxes can be used with the buff. The buff is fastened
onto a rubber backing pad with laces. Make sure the diameter of the polishing buff is
the same as the backing pad's diameter.
It is necessary to polish a vehicle body panel when:
- The panel has been newly painted with a clear-coat.
- Shallow scratch marks need to be removed.
- The panel has suffered from oxidation.
- Swirl marks and hologram defects need to be removed.
TIP:
The buff is washable after use if the polishing compound is soluble.
Tie on polishing wool buff range:
| ORDER NO. | DIAMETER | USE BACKING PAD |
| MM4 | 100mm | |
MM5 | 125mm | TCBP125C / PG338 |
MM6 | 150mm | TCBP150C |
MM7 | 180mm | PG33805 |
MM7-2 | 180mm | PG33805 |
MM8 | 200mm | |
MM9 | 230mm | |
MM9-2 | 230mm | |
MM10 | 250mm |
Recommended polishing compounds to use:
Liquid Shine
High cut - Features a silicone, wax and filler free polishing
compound to give a high gloss finish on fresh or cured paint. It is capable
of removing P1500 grit sanding marks. It can be used on automotive paints,
marine gel-coats and on composite surfaces.
Liquid Shine
Fine cut - similar to the High cut polishing compound, but it
is designed for use on a ceramic and scratch resistant clear-coat. It is
capable of removing P2000 scratch marks.
Liquid Shine
Zero swirl - Very low abrasive for the final step of polishing.
Removes holograms and swirl marks. Use a soft compounding sponge as a final
step
