This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1654
Similar products
4 In 1 Charger Discharger Boost 5V 2.1A Module for 3.7V 4.2V Battery DIY Mobile Power with Button
New
R352.00
Closed
11 May 24 00:19
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612430204
Description
trigger: input LOW(grounding)
Single Chip Using: If Small load KEY connect 20S single chip and supply with input LOW, the module will work well.
Charge voltage: DC 4.5V-5.5V(Recommend DC 5V)?? ?
Charging current: 0-2.1A
Charge quiescent current: 100uA
Full charge voltage: 4.2V+-1%
Discharge current: 0-2.4A
Discharge quiescent current:50uA
Discharge conversion efficiency: MAX 96%
Output voltage: 5V
Output current: 0-2.4A
Operating ambient temperature: -20?ﾣto +85?ﾣ
Size: 25x16x4mm
Weight: 2.3g
PCB board design: Immersion Gold
Battery protection: OCP/OVP/SCP/OTP
About module pin
1 VIN: charge port +
2 GND: charge port -
3 BAT: Battery +
4 GND: Battery -
5 GND: output -
6 VOUT: output +
7 KEY: trigger
Note:
1.In discharging mode(charging mode KEY function invalid), trigger KEY one time,output open; trigger two times, output close.
2.Output will open automatically if you connect load. If load below 50MA, the module will turn off output port; if load over 50MA, output port will always open.
3.Allow charging and discharging at the same time(output voltage should below 5V.Stop charging and stop discharging,you should reactivation the module.)
Package
1x module
1x button