4 PCS Silk Wire Deficiency Tin With Low Residue Strip BGA To Remove Tin Welding Strip Electronic ...
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0595726701
Bob Shop ID
593638235
1. Material: copper, plastic
2. Scope of application: suitable for cleaning soldering tin on PCB boards, etc.
3. It adopts flat needle weaving, soft design, fast heat conduction, suitable for fast tin sucking, improve work efficiency, and be more environmentally friendly
4. Fast tin absorption, low residue, used to absorb excess solder when removing tin, oxidation and corrosion resistance, good thermal conductivity and tin absorption performance, clean tin absorption
5. Width: 2/2.5/3/3.5mm
6. Length: about 1.5 meters/piece
7. Weight: about 7g/piece for 2mm, about 8g/piece for 2.5mm, about 9g/piece for 3mm, 10g/piece for 3.5mm
Steps for usage:
1. For the solder that you want to remove, put an appropriate length of the suction wire on the cleaned solder point, and then use the electric soldering iron nozzle to lightly heat it, and the solder will be sucked by the suction wire after the solder melts
2. When the solder is absorbed, remove the soldering iron and the suction wire at the same time
3. Cut off the used suction wire with cutting pliers