Name: 433Mhz Geekcreit DC 12V 10A Relay 1Channel Wireless RF Remote Control Relay
SKU: 1242
Price: 252.89 ZAR
Availability: SoldOut

433Mhz Geekcreit DC 12V 10A Relay 1Channel Wireless RF Remote Control Relay

New

2 were available

Indicative market price: R278.18

R252.89

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

PiShop SA2548

99.21 % Positive ratings

Buyer protection

How you're covered

Condition

New

Location

South Africa

Product code

1242

Bob Shop ID

576238040

Description:

It is a learning code wireless remote control switch (receiver), the output way /working way can be changed as you like. It is easy to match the transmitter. A Relay which can make the equipment turn or reverse, on/off. The volume is small and the performance is stable and reliable, with high receive sensitivity.

Features:

Easy to use.
Operating Voltage: DC12V
Maximum Load: 10A
Operating Frequency: 433MHZ
Receiver Sensitivity: -100dBm
Encoding Type: learning code
Board Size: Approx. 5.3x3.1cm/ 2.09x1.22"

Relay rating:

10A 250VAC
10A 125VAC
10A 30VDC
10A 28VDC

To check compatibility of a new remote with the receiver. Simply press the button on the remote, if the receiver flashes, but does not Triger the relay. The remote will be compatible, and you can start the programing process

To add a remote, press the button on receiver momentarily. The red light will come on. Then press the button on the remote that you want to program in. The red light will start flashing. After 4 flashes in will stop, and the button will be programmed in.

For the setting to take effect, the board needs to be disconnected from it's power supply. The bellow settings will be done to the 3 headers and bridge pin on the receiver board, above the push button.

With the header removed, the On button will switch the relay on, and the off button will in turn switch the relay off.
With the header on Pin 1-2. Both Buttons will become momentary. And only hold the relay in place as long as they are pressed in.
With the header on Pin 2-3. Each button will be able to switch the relay on and off individually. You will however not be able to switch the button off with the "off" button, if you switched it on with the "on" button. And vise versa.

Package Includes:

1 x Learning Code Receiver Relay
1 x Remote Control