433Mhz Geekcreit® DC 12V 10A Relay 1Channel Wireless RF Remote Control Relay

It is a learning code wireless remote control switch (receiver), the output way /working way can be changed as you like. It is easy to match the transmitter. A Relay which can make the equipment turn or reverse, on/off. The volume is small and the performance is stable and reliable, with high receive sensitivity.

Features

Easy to use.
Operating Voltage: DC12V
Maximum Load: 10A
Operating Frequency: 433MHZ
Receiver Sensitivity: -100dBm
Encoding Type: learning code
Board Size: Approx. 5.3x3.1cm/ 2.09x1.22"

Relay rating

• 10A 250VAC
• 10A 125VAC
• 10A 30VDC
• 10A 28VDC

To check compatibility of a new remote with the receiver. Simply press the button on the remote, if the receiver flashes, but does not Triger the relay. The remote will be compatible, and you can start the programing process

To add a remote, press the button on receiver momentarily. The red light will come on. Then press the button on the remote that you want to program in. The red light will start flashing. After 4 flashes in will stop, and the button will be programmed in.

For the setting to take effect, the board needs to be disconnected from it's power supply. The bellow settings will be done to the 3 headers and bridge pin on the receiver board, above the push button.

• With the header removed, the On button will switch the relay on, and the off button will in turn switch the relay off.
• With the header on Pin 1-2. Both Buttons will become momentary. And only hold the relay in place as long as they are pressed in.
• With the header on Pin 2-3. Each button will be able to switch the relay on and off individually. You will however not be able to switch the button off with the "off" button, if you switched it on with the "on" button. And vise versa.

What's in the box?

1 x Learning Code Receiver Relay
1 x Remote Control





Note: Stock is currently available in South Africa for national shipping!