This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1816
4pcs Mg996r Analog Servo Metal Gear Torque for Smart Car Robot Boat
New
R677.00
Closed
22 May 24 15:29
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613487330
2 Set Electronic Accessories: 4 x MG996R Mini Servo motor & 1 set x A4988 Stepper Motor Driver1.MG996R Mini Servo motor, which updated from SG90 Mini Servo and MG90S Mini servo motor. The speed, tension and accuracy all increase.2.Compatible with most standard receiver connector: Futaba, Hitec, Sanwa, JR.3.Torsional moment: 12kg/cm(6V), 13kg.cm.at(7.2V), Recommended voltage: 5V, current usage: 3A4.Stable and shock proof, metal gear, connector wire length 300mm.Colour: Photo ColorMaterial: PC+ metal+plasticA4988 Stepper Motor Driver: CNC Shield Board: Latest CNC Shield Version 3.0 for Arduino.GRBL 0.9 compatible. (Open source firmware that runs on an for Arduino that turns G-code commands into stepper signals).PWM Spindle and direction pins.4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13).2 x End stops for each axis (6 in total)Coolant enable,Uses removable A4988 or DRV8825 compatible stepper driversJumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping ).Compact design.Stepper Motors can be connected with 4 pin molex connectors or soldered in place.MG996R Mini Servo motor: Mini Servo Motor for 1:10 RC car robot helicopter servo remote controlled aircraft for DIY.size:40.8 x 20.1 x 38mmPackage Contents:4 x MG996R Mini Servo motor1 x CNC Shield Board4 x A4988 Stepper Motor Driver4 x Heat SinkNote: Green or Red PCBOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.