50CM USB3.0 Rear PCI Baffle Line Full Height Chassis DIY With Ear 20pin Transfer Cable(Blue)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD076645001B
Bob Shop ID
593639564
1. Wire: 24+28AWG OD: 6.0mm
2. Plug: nickel-plated shell, gold-plated terminals 3
3. Inner mold: transparent PE material
4. Outer mold: environmental protection PVC material
5. Length: 0.5 meters
6. Weight: 85g
7. Applicable: It is used to extend the USB3.0 high-speed interface of the computer chassis PCI position, using the motherboard 20P header to transfer to two USB3.0 female ports, fixed on the rear of the chassis PCI baffle position to facilitate the connection of the device
8. To use this extension cable, the chassis motherboard must have a 20P expansion port. When the connected device cannot be used normally, make sure that the 20P is fully inserted, the system driver and the connected device are normal.