54W RGB Remote Control LED Swimming Pool Light Underwater Waterproof Wall Mounted Night Light

20 available / new

R2,396.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3514

93.45 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Condition

New

Location

International

Bob Shop ID

643367796

Specification:
Power: 54W
LED Chips Type: SMD2835
Beam Angle: 120 deg
Frequency: 50~60Hz
IP Rating: IP68
Installation Location: 0.6m below water level
Cable Length: 135cm
Remote Control: Within the scope of 50M

Features:
-18Pcs 3W lamp beads LEDs-super bright & crisp colors.
-Plastic housing makes it acid-proof and alkali-proof.
-Supports 15 different kinds of color styles.
-The lamp is filled with resin inside, which makes it 100% waterproof.
-Easy to install, fitting to standard pool fittings.
-Compatible for both fresh or salt water pool.

Remote Control Operation:
a On/Off: Power switch function,press the key for turning on or turning off the light.
a Mode: Modes selection,the light can be turned to the first program when press this key for 5 seconds at any working program.
a 15 pre-programmed color modes of RGB light.
1.R-G-B change gradually to full modes
2.RG:Static state yellow
3:RB:Static state purple
4.GB:Static cyan-blue
5.RGB-RG-G-GB-B-R animation
6.RB-GB-B animation
7.R-G animation
8.B-R animation
9.G-B animation
10.RB-B animation
11.G-GB animation
12.R:Static state red
13.B:Static state blue
14.G:Static state green
15.RGB:Static state white
a S+/S:Adjust the color changing speed,there are total 10 adjusting levels.

Note:
You will need a AC12V transformer to power the lights. If it is more than AC 12V it will damage the light.

Package Included:
1 x LED Light
1 x Remote Control (1x Alkalinebattery 23A/12V not inculude )
1 x Waterproof Connector