5V 2A Charge and Discharge Boost Module 3.7V/4.2V
Check my rate
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
A combined single-cell lithium battery charger, boost converter and protection board. It charges a 3.7V nominal (4.2V full) cell and boosts the battery to a regulated 5V output, so one board handles charging, discharging and battery protection.
Power and charging
- Charging input: DC 4.5V to 5.5V (5V recommended)
- Charging current: 0 to 2.1A
- Charging quiescent current: 100uA
- Full charge voltage: 4.2V ±1%
- Discharge current: 0 to 2.4A
- Discharge quiescent current: 50uA
- Discharge efficiency: up to 96%
- Output voltage: 5V
- Output current: 0 to 2.4A
Battery
Use a single 3.7V lithium cell only. Do not wire cells in series. The cell must be rated to accept a 2.1A charge current. The board includes lithium battery protection, so a cell without its own protection board can be used; a protected cell also works.
Protection
- Over-current protection (OCP)
- Overvoltage protection (OVP)
- Short circuit protection (SCP)
- Over-temperature protection (OTP)
Output and indicators
The 5V output is normally on and is not affected by load connection. Maximum load current is 2A. Four LED indicators show charge and discharge level. Output can be button-controlled, and a low-level trigger (ground) on the KEY point lets a microcontroller keep the module running.
Size and environment
- Board size: 25 x 16 x 4mm
- Weight: 2.3g
- Ambient temperature: -20°C to +85°C
Notes
The module does not include wiring harnesses, battery cells or mounting hardware. The title states 5V/2A while the technical specifications list a 2.4A discharge rating; the 2A figure is the stated maximum load current.