Sensor Photoresistor Relay Light Control Module 5V DC **LOCAL STOCK**

New
-+
2 available
R80.00
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Free collection from Vasco Estate, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready. Ready for collection by Wednesday, 19 June.
Ready to ship in
The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Get it now, pay later
Seller
Buyer Protection

Product details

Condition
New
Location
South Africa
Product code
SEN114
Bob Shop ID
616081564

5V Sensor Photoresistor Relay Light Control Module:

 

Product Description:

Stable version of the module is 5V supply, without delay function, pull relay matt, bright disconnect


Uses:

Light detection and brightness detection, detection can be adjusted via potentiometer brightness valve point comes relays, and do all kinds of brightness detection switch, you can control all kinds of street lights automatically turn on at night, during the day and automatically turns off and car supplies control and automation equipment.


Module Features:

Using the photoresistor induction light intensity comes with the relay, direct control load

Distribution bit sensitivity adjustment, start relay threshold set by adjusting potentiometer, when the dark this threshold, the module relay is energized, bright this threshold, the relay release

5V power input is designed for relay board regulator transistor to provide sensor Used to make the product more stable and reliable;

Onboard optocoupler isolation drive relay, the effective protection of the chip to make the product work more reliable

Has four fixed bolt hole for easy installation


Module using the Instructions:

Photoresistors module is most sensitive to ambient light, generally used to detect the brightness of the ambient light.

The module when the ambient light is darker than the threshold value is set, the relay is energized, the common terminal and the normally start is turned on, when external ambient light is brighter than the set threshold value, the relay is switched off, the common terminal and the normally closed end connected

The public side, normally open, normally closed three ports, the equivalent of a dual-control switch, relay coil power, public end and often the beginning of conduction, radio, public end normally closed terminal conduction


Electrical parameters:

Supply voltage: 5VDC
Load: 250V 10A AC or 30V 10A DC (the current is less than this range can be used)



 

Please see all our listings here:
https://www.bidorbuy.co.za/seller/4397469

More from this seller

View all
Switch Push Button BLACK Square 12mm 2 Pin On-Off **LOCAL STOCK**
R8
R30 shipping
Battery Voltage, Capacity, Percentage, Temperature, Power Meter DC 8 to 100V **LOCAL STOCK**
R175
R30 shipping
Temperature Controller Digital Thermostat Thermometer 12V DC (Model W1401) **LOCAL STOCK**
R129
R30 shipping
Temperature Controller Thermostat Thermometer Digital DC 12V 20A Probe **LOCAL STOCK**
R125
Add to cart

Similar products

DC-DC Step Down Power Module 3A 48V DC **LOCAL STOCK**
R47
5V DC Relay Module 1 Channel with Infrared Remote for AC/DC Loads **LOCAL STOCK**
R90
Switch Hand Sensor Module 5-24V for Led Strips 6 Modes **LOCAL STOCK**
R45
R30 shipping
Controller Relay 5V DC 4 Channel Module Board **LOCAL STOCK**
R115