Adafruit 16-Channel PWM / Servo HAT for Raspberry Pi - Mini Kit

Control 16 Servos with perfect timing!

This HAT can also do PWM up to 1.6 KHz with 12 bit precision, all completely free-running.

For use with Raspberry Pi Model A+ or B+, can be used with the Model A or B if you use a tall 2x13 header instead of the included 2x20.

• drive up to 16 servos or PWM outputs over I2C with only 2 pins.
• The on-board PWM controller will drive all 16 channels simultaneously with no additional Raspberry Pi processing overhead.
• stack up to 62 HATs to control up to 992 servos - all with the same 2 pins!

Best of all, Adafruit even have a Python library you can use, so you'll be up and running instantly, to make your robotic creation com to life. The Adafruit PWM/Servo HAT is the perfect solution for any project that requires a lot of servos or PWM outputs! Check out Adafruits detailed tutorial for lots more information including diagrams, schematics, installation instructions and more

Each order contains

• a Servo HAT
• a 2-pin terminal block
• four 3x4 headers
• a 2x20 socket header

You'll need to do some light through-hole soldering to attach the headers onto the HAT circuit board. If you would like to stack multiple HATs onto one Pi, you can also pick up a 2x20 stacking header and a set of right-angle 3x4 headers that should be soldered on instead.

Please note! This kit does not come with Raspberry Pi, servos, or required 5V power supply.