Aircraft Elbow W/O-Ring 12Mm-1/8 M Pu Hose Fitting

AirCraft Elbow With O-ring 12mm-1/8" M BSP PU Hose Fitting

At a Glance: 12mm push-in tube connection to 1/8" Male BSP thread with an O-ring seal in a compact 90° elbow.

Bigger tubing, tighter spaces, and no time for messy routing. The AirCraft Elbow With O-ring 12mm-1/8" M BSP PU Hose Fitting is a push-in pneumatic elbow that connects 12mm tubing to a 1/8" BSP female port while giving you a clean 90° turn right at the connection point. The integrated O-ring supports sealing at the port face on compatible connections, helping reduce leak risk and keep your compressed-air layout looking professional. Ideal for compressors, regulators, FRLs, manifolds and pneumatic systems where tidy routing and dependable connections matter.

Specifications

Features

• Push-in 12mm tube connection Tool-free tube installation and removal for faster servicing.
• 1/8" Male BSP thread Fits common BSP ports on compact pneumatic components and control hardware.
• O-ring sealed thread Helps enhance sealing at the port face on compatible ports and fittings.
• 90° elbow configuration Improves routing, reduces tube stress and helps prevent kinks.

Benefits

• Neater routing: Keeps 12mm tubing runs tidy and reduces strain at the port connection.
• Improved leak resistance: O-ring support plus correct tube insertion helps minimise air loss.
• Faster maintenance: Push-in design speeds up tube swaps and line changes.

Extra Information

• Use with 12mm OD PU or nylon pneumatic tubing. Square-cut tube ends give the best seal.
• Thread check: This fitting is 1/8" Male BSP. Confirm your port is BSP (not NPT) before installation.
• O-ring sealing works best on compatible port faces. Depending on your equipment, a suitable thread sealant may still be recommended.

Safety

• Isolate and depressurise the air system before installing or removing pneumatic fittings.
• Wear eye protection when working with compressed air and pressurised lines.
• Do not over-tightenexcess force can damage threads, distort sealing faces or crush the O-ring.
• After installation, leak-test the joint before returning equipment to service.
• Use only within the rated limits of your pneumatic system and with compatible tubing/materials.