Aircraft Metal Swiv. Elbow 4Mm X 1/4' M

AirCraft Metal Swivel Elbow 4mm x 1/4' Male (SG MPH04-02)

At a Glance; 4mm push-in tube connection to 1/4" male thread in a compact 90° swivel elbow.

The AirCraft SG MPH04-02 Metal Swivel Elbow is built for clean, confidence-inspiring pneumatic installations where space is tight and air lines must turn neatly. It connects 4mm pneumatic tubing to a 1/4" male threaded port, and the swivel design allows you to orient the elbow perfectly after tighteningâ"helping prevent tube twist and awkward line stress. A solid choice for compressed-air setups on valves, regulators, manifolds, cylinders and workshop equipment where a tidy route and a reliable seal matter.

Specifications

Features

• Swivel elbow body Rotates for easy alignment after tightening, improving routing and reducing tube twist.
• 4mm push-in tube connection Quick, secure tubing installation for efficient assembly and servicing.
• 1/4" male threaded outlet Fits common pneumatic ports on regulators, manifolds and air control components.
• Metal construction Robust, workshop-ready durability for everyday compressed-air use.

Benefits

• Cleaner routing; Turns corners neatly in compact spaces without kinks or ugly bends.
• Less stress on tubing; Swivel alignment helps reduce strain that can cause leaks or premature wear.
• Faster maintenance; Push-in connection speeds up installations, replacements and system changes.

Extra Information

• Use a suitable thread sealant/PTFE tape on the male thread if required by your application and port type.
• For best results, cut pneumatic tubing square and keep the tube end clean before inserting.
• After insertion, pull back gently to confirm the tube is locked, then pressurise and check for leaks with soapy water.

Safety

• Always depressurise the air system before installing or removing pneumatic fittings.
• Wear eye protection when working with compressed air and pressurised lines.
• Do not exceed your system's rated pressure and inspect tubing for cracks, cuts or wear.
• Pressurise slowly after installation and check all joints for leaks using soapy water (never use open flames).