Aircraft Pu Hose Fitting Elbow 10Mm-3/8 F

AirCraft PU Hose Fitting Elbow 10mm-3/8" F BSP

At a Glance: 10mm push-in to 3/8" female BSP elbowâ"compact 90° routing with a larger threaded connection.

When you need a clean corner turn plus a larger threaded port, the AirCraft PU Hose Fitting Elbow 10mm-3/8" F BSP is the tidy solution for compressed-air and pneumatic systems. The push-in side accepts 10mm PU tubing for fast, tool-free installation, while the 3/8" female BSP thread connects to compatible pneumatic ports and adapters on manifolds, regulators, valves and pneumatic panels. The 90-degree elbow design helps prevent kinks, reduces strain on tubing and ports, and keeps your hose routing controlledâ"especially in tight assemblies where straight fittings would cause stress and mess.

Specifications

Features

• Push-in tube connection Tool-free installation with 10mm PU tubing.
• 90° elbow design Helps prevent tight bends and keeps tubing runs tidy.
• 3/8" Female BSP thread Suits compatible BSP pneumatic ports and adapters.
• Compact, practical body Fits into tight assemblies while keeping line runs controlled.
• Reliable sealing interface Designed for consistent performance in normal pneumatic applications.

Benefits

• Cleaner system layout: Improves hose management and access around components.
• Reduced tubing stress: Minimises strain to help reduce kinks and premature tubing wear.
• Faster maintenance: Push-in convenience speeds up servicing and tube changes.

Extra Information

• Use with 10mm outer-diameter PU tubingcut square and insert fully until seated for best sealing.
• Confirm BSP thread compatibility and sealing method requirements for the threaded side based on the mating component.
• To remove the tube, depress the collet evenly and pull the tubing straight outavoid twisting the tube end.

Safety

• Wear eye, ear and dust protection where applicable when working around pressurised air systems.
• Depressurise the system completely before installing, removing, or servicing pneumatic fittings.
• Check for leaks after installation using a suitable leak-detection method and re-check after initial operation.
• Ensure tubing is correctly sized, fully seated, and all connected components are compatible before pressurising.