Aircraft Pu Hose Fitting Elbow 6Mm-1/2 F

AirCraft PU Hose Fitting Elbow 6mm-1/2" F BSP

At a Glance: 6mm push-in to 1/2" female BSP elbowâ"compact 90° routing with a larger threaded connection.

Need a neat 90-degree turn for 6mm PU tubing, but with a larger threaded port? The AirCraft PU Hose Fitting Elbow 6mm-1/2" F BSP is built for clean routing and dependable connections in compressed-air and pneumatic systems. The push-in side makes tube installation quick and simple, while the 1/2" female BSP thread connects to compatible ports and adapters on manifolds, valves, regulators and pneumatic panels. This elbow design helps prevent kinks, reduces tubing strain, and keeps your setup organisedâ"especially in tight spaces where straight fittings just donât play nicely.

Specifications

Features

• Push-in tube connection Tool-free installation with 6mm PU tubing.
• 90° elbow body Supports tidy hose routing and helps avoid tight bends.
• 1/2" Female BSP thread Suits compatible BSP pneumatic ports and adapters.
• Compact, practical design Fits into tight assemblies while keeping lines controlled.
• Reliable sealing interface Designed for consistent performance in normal pneumatic applications.

Benefits

• Cleaner system layout: Keeps tubing runs neat and improves access around components.
• Reduced tubing stress: Minimises kinks and strain, helping extend tubing life.
• Faster maintenance: Push-in convenience speeds up tube changes and troubleshooting.

Extra Information

• Use with 6mm outer-diameter PU tubingcut the tube square and insert fully until seated.
• Confirm BSP thread standard and sealing method required for the threaded side, depending on the mating component.
• To remove the tube, depress the collet and pull the tubing straight outavoid twisting the tube end.

Safety

• Wear eye, ear and dust protection where applicable when working around pressurised air systems.
• Depressurise the system completely before installing, removing, or servicing pneumatic fittings.
• Test for leaks after installation using a suitable leak-detection method and re-check after initial operation.
• Ensure tubing is correctly sized, fully seated, and all connected components are compatible before pressurising.